blob: 406252d14c6b32cb72b04078b4818459853f411c [file] [log] [blame]
USB EHCI controllers
Required properties:
- compatible : should be "generic-ehci".
- reg : should contain at least address and length of the standard EHCI
register set for the device. Optional platform-dependent registers
(debug-port or other) can be also specified here, but only after
definition of standard EHCI registers.
- interrupts : one EHCI interrupt should be described here.
Optional properties:
- big-endian-regs : boolean, set this for hcds with big-endian registers
- big-endian-desc : boolean, set this for hcds with big-endian descriptors
- big-endian : boolean, for hcds with big-endian-regs + big-endian-desc
- needs-reset-on-resume : boolean, set this to force EHCI reset after resume
- has-transaction-translator : boolean, set this if EHCI have a Transaction
Translator built into the root hub.
- clocks : a list of phandle + clock specifier pairs. In case of Renesas
R-Car Gen3 SoCs:
- if a host only channel: first clock should be host.
- if a USB DRD channel: first clock should be host and second one
should be peripheral.
- phys : see usb-hcd.txt in the current directory
- resets : phandle + reset specifier pair
additionally the properties from usb-hcd.txt (in the current directory) are
supported.
Example (Sequoia 440EPx):
ehci@e0000300 {
compatible = "ibm,usb-ehci-440epx", "usb-ehci";
interrupt-parent = <&UIC0>;
interrupts = <1a 4>;
reg = <0 e0000300 90 0 e0000390 70>;
big-endian;
};
Example (Allwinner sun4i A10 SoC):
ehci0: usb@1c14000 {
compatible = "allwinner,sun4i-a10-ehci", "generic-ehci";
reg = <0x01c14000 0x100>;
interrupts = <39>;
clocks = <&ahb_gates 1>;
phys = <&usbphy 1>;
phy-names = "usb";
};