blob: 77f4b0a7fd2b0058d1e6858278acd16e815b783b [file] [log] [blame] [edit]
Freescale i.MX Media Video Device
=================================
Video Media Controller node
---------------------------
This is the media controller node for video capture support. It is a
virtual device that lists the camera serial interface nodes that the
media device will control.
Required properties:
- compatible : "fsl,imx-capture-subsystem";
- ports : Should contain a list of phandles pointing to camera
sensor interface ports of IPU devices
example:
capture-subsystem {
compatible = "fsl,imx-capture-subsystem";
ports = <&ipu1_csi0>, <&ipu1_csi1>;
};
mipi_csi2 node
--------------
This is the device node for the MIPI CSI-2 Receiver core in the i.MX
SoC. This is a Synopsys Designware MIPI CSI-2 host controller core
combined with a D-PHY core mixed into the same register block. In
addition this device consists of an i.MX-specific "CSI2IPU gasket"
glue logic, also controlled from the same register block. The CSI2IPU
gasket demultiplexes the four virtual channel streams from the host
controller's 32-bit output image bus onto four 16-bit parallel busses
to the i.MX IPU CSIs.
Required properties:
- compatible : "fsl,imx6-mipi-csi2";
- reg : physical base address and length of the register set;
- clocks : the MIPI CSI-2 receiver requires three clocks: hsi_tx
(the D-PHY clock), video_27m (D-PHY PLL reference
clock), and eim_podf;
- clock-names : must contain "dphy", "ref", "pix";
- port@* : five port nodes must exist, containing endpoints
connecting to the source and sink devices according to
of_graph bindings. The first port is an input port,
connecting with a MIPI CSI-2 source, and ports 1
through 4 are output ports connecting with parallel
bus sink endpoint nodes and correspond to the four
MIPI CSI-2 virtual channel outputs.
Optional properties:
- interrupts : must contain two level-triggered interrupts,
in order: 100 and 101;