| // SPDX-License-Identifier: GPL-2.0-or-later |
| /* |
| * Copyright (c) 2011-2016 Zhang, Keguang <keguang.zhang@gmail.com> |
| */ |
| |
| #include <linux/clk.h> |
| #include <linux/dma-mapping.h> |
| #include <linux/err.h> |
| #include <linux/mtd/partitions.h> |
| #include <linux/sizes.h> |
| #include <linux/phy.h> |
| #include <linux/serial_8250.h> |
| #include <linux/stmmac.h> |
| #include <linux/usb/ehci_pdriver.h> |
| |
| #include <platform.h> |
| #include <loongson1.h> |
| |
| /* 8250/16550 compatible UART */ |
| #define LS1X_UART(_id) \ |
| { \ |
| .mapbase = LS1X_UART ## _id ## _BASE, \ |
| .irq = LS1X_UART ## _id ## _IRQ, \ |
| .iotype = UPIO_MEM, \ |
| .flags = UPF_IOREMAP | UPF_FIXED_TYPE, \ |
| .type = PORT_16550A, \ |
| } |
| |
| static struct plat_serial8250_port ls1x_serial8250_pdata[] = { |
| LS1X_UART(0), |
| LS1X_UART(1), |
| LS1X_UART(2), |
| LS1X_UART(3), |
| {}, |
| }; |
| |
| struct platform_device ls1x_uart_pdev = { |
| .name = "serial8250", |
| .id = PLAT8250_DEV_PLATFORM, |
| .dev = { |
| .platform_data = ls1x_serial8250_pdata, |
| }, |
| }; |
| |
| void __init ls1x_serial_set_uartclk(struct platform_device *pdev) |
| { |
| struct clk *clk; |
| struct plat_serial8250_port *p; |
| |
| clk = clk_get(&pdev->dev, pdev->name); |
| if (IS_ERR(clk)) { |
| pr_err("unable to get %s clock, err=%ld", |
| pdev->name, PTR_ERR(clk)); |
| return; |
| } |
| clk_prepare_enable(clk); |
| |
| for (p = pdev->dev.platform_data; p->flags != 0; ++p) |
| p->uartclk = clk_get_rate(clk); |
| } |
| |
| /* Synopsys Ethernet GMAC */ |
| static struct stmmac_mdio_bus_data ls1x_mdio_bus_data = { |
| .phy_mask = 0, |
| }; |
| |
| static struct stmmac_dma_cfg ls1x_eth_dma_cfg = { |
| .pbl = 1, |
| }; |
| |
| int ls1x_eth_mux_init(struct platform_device *pdev, void *priv) |
| { |
| struct plat_stmmacenet_data *plat_dat = NULL; |
| u32 val; |
| |
| val = __raw_readl(LS1X_MUX_CTRL1); |
| |
| #if defined(CONFIG_LOONGSON1_LS1B) |
| plat_dat = dev_get_platdata(&pdev->dev); |
| if (plat_dat->bus_id) { |
| __raw_writel(__raw_readl(LS1X_MUX_CTRL0) | GMAC1_USE_UART1 | |
| GMAC1_USE_UART0, LS1X_MUX_CTRL0); |
| switch (plat_dat->phy_interface) { |
| case PHY_INTERFACE_MODE_RGMII: |
| val &= ~(GMAC1_USE_TXCLK | GMAC1_USE_PWM23); |
| break; |
| case PHY_INTERFACE_MODE_MII: |
| val |= (GMAC1_USE_TXCLK | GMAC1_USE_PWM23); |
| break; |
| default: |
| pr_err("unsupported mii mode %d\n", |
| plat_dat->phy_interface); |
| return -ENOTSUPP; |
| } |
| val &= ~GMAC1_SHUT; |
| } else { |
| switch (plat_dat->phy_interface) { |
| case PHY_INTERFACE_MODE_RGMII: |
| val &= ~(GMAC0_USE_TXCLK | GMAC0_USE_PWM01); |
| break; |
| case PHY_INTERFACE_MODE_MII: |
| val |= (GMAC0_USE_TXCLK | GMAC0_USE_PWM01); |
| break; |
| default: |
| pr_err("unsupported mii mode %d\n", |
| plat_dat->phy_interface); |
| return -ENOTSUPP; |
| } |
| val &= ~GMAC0_SHUT; |
| } |
| __raw_writel(val, LS1X_MUX_CTRL1); |
| #elif defined(CONFIG_LOONGSON1_LS1C) |
| plat_dat = dev_get_platdata(&pdev->dev); |
| |
| val &= ~PHY_INTF_SELI; |
| if (plat_dat->phy_interface == PHY_INTERFACE_MODE_RMII) |
| val |= 0x4 << PHY_INTF_SELI_SHIFT; |
| __raw_writel(val, LS1X_MUX_CTRL1); |
| |
| val = __raw_readl(LS1X_MUX_CTRL0); |
| __raw_writel(val & (~GMAC_SHUT), LS1X_MUX_CTRL0); |
| #endif |
| |
| return 0; |
| } |
| |
| static struct plat_stmmacenet_data ls1x_eth0_pdata = { |
| .bus_id = 0, |
| .phy_addr = -1, |
| #if defined(CONFIG_LOONGSON1_LS1B) |
| .phy_interface = PHY_INTERFACE_MODE_MII, |
| #elif defined(CONFIG_LOONGSON1_LS1C) |
| .phy_interface = PHY_INTERFACE_MODE_RMII, |
| #endif |
| .mdio_bus_data = &ls1x_mdio_bus_data, |
| .dma_cfg = &ls1x_eth_dma_cfg, |
| .has_gmac = 1, |
| .tx_coe = 1, |
| .rx_queues_to_use = 1, |
| .tx_queues_to_use = 1, |
| .init = ls1x_eth_mux_init, |
| }; |
| |
| static struct resource ls1x_eth0_resources[] = { |
| [0] = { |
| .start = LS1X_GMAC0_BASE, |
| .end = LS1X_GMAC0_BASE + SZ_64K - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| [1] = { |
| .name = "macirq", |
| .start = LS1X_GMAC0_IRQ, |
| .flags = IORESOURCE_IRQ, |
| }, |
| }; |
| |
| struct platform_device ls1x_eth0_pdev = { |
| .name = "stmmaceth", |
| .id = 0, |
| .num_resources = ARRAY_SIZE(ls1x_eth0_resources), |
| .resource = ls1x_eth0_resources, |
| .dev = { |
| .platform_data = &ls1x_eth0_pdata, |
| }, |
| }; |
| |
| #ifdef CONFIG_LOONGSON1_LS1B |
| static struct plat_stmmacenet_data ls1x_eth1_pdata = { |
| .bus_id = 1, |
| .phy_addr = -1, |
| .phy_interface = PHY_INTERFACE_MODE_MII, |
| .mdio_bus_data = &ls1x_mdio_bus_data, |
| .dma_cfg = &ls1x_eth_dma_cfg, |
| .has_gmac = 1, |
| .tx_coe = 1, |
| .rx_queues_to_use = 1, |
| .tx_queues_to_use = 1, |
| .init = ls1x_eth_mux_init, |
| }; |
| |
| static struct resource ls1x_eth1_resources[] = { |
| [0] = { |
| .start = LS1X_GMAC1_BASE, |
| .end = LS1X_GMAC1_BASE + SZ_64K - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| [1] = { |
| .name = "macirq", |
| .start = LS1X_GMAC1_IRQ, |
| .flags = IORESOURCE_IRQ, |
| }, |
| }; |
| |
| struct platform_device ls1x_eth1_pdev = { |
| .name = "stmmaceth", |
| .id = 1, |
| .num_resources = ARRAY_SIZE(ls1x_eth1_resources), |
| .resource = ls1x_eth1_resources, |
| .dev = { |
| .platform_data = &ls1x_eth1_pdata, |
| }, |
| }; |
| #endif /* CONFIG_LOONGSON1_LS1B */ |
| |
| /* GPIO */ |
| static struct resource ls1x_gpio0_resources[] = { |
| [0] = { |
| .start = LS1X_GPIO0_BASE, |
| .end = LS1X_GPIO0_BASE + SZ_4 - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| }; |
| |
| struct platform_device ls1x_gpio0_pdev = { |
| .name = "ls1x-gpio", |
| .id = 0, |
| .num_resources = ARRAY_SIZE(ls1x_gpio0_resources), |
| .resource = ls1x_gpio0_resources, |
| }; |
| |
| static struct resource ls1x_gpio1_resources[] = { |
| [0] = { |
| .start = LS1X_GPIO1_BASE, |
| .end = LS1X_GPIO1_BASE + SZ_4 - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| }; |
| |
| struct platform_device ls1x_gpio1_pdev = { |
| .name = "ls1x-gpio", |
| .id = 1, |
| .num_resources = ARRAY_SIZE(ls1x_gpio1_resources), |
| .resource = ls1x_gpio1_resources, |
| }; |
| |
| /* USB EHCI */ |
| static u64 ls1x_ehci_dmamask = DMA_BIT_MASK(32); |
| |
| static struct resource ls1x_ehci_resources[] = { |
| [0] = { |
| .start = LS1X_EHCI_BASE, |
| .end = LS1X_EHCI_BASE + SZ_32K - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| [1] = { |
| .start = LS1X_EHCI_IRQ, |
| .flags = IORESOURCE_IRQ, |
| }, |
| }; |
| |
| static struct usb_ehci_pdata ls1x_ehci_pdata = { |
| }; |
| |
| struct platform_device ls1x_ehci_pdev = { |
| .name = "ehci-platform", |
| .id = -1, |
| .num_resources = ARRAY_SIZE(ls1x_ehci_resources), |
| .resource = ls1x_ehci_resources, |
| .dev = { |
| .dma_mask = &ls1x_ehci_dmamask, |
| .platform_data = &ls1x_ehci_pdata, |
| }, |
| }; |
| |
| /* Real Time Clock */ |
| struct platform_device ls1x_rtc_pdev = { |
| .name = "ls1x-rtc", |
| .id = -1, |
| }; |
| |
| /* Watchdog */ |
| static struct resource ls1x_wdt_resources[] = { |
| { |
| .start = LS1X_WDT_BASE, |
| .end = LS1X_WDT_BASE + SZ_16 - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| }; |
| |
| struct platform_device ls1x_wdt_pdev = { |
| .name = "ls1x-wdt", |
| .id = -1, |
| .num_resources = ARRAY_SIZE(ls1x_wdt_resources), |
| .resource = ls1x_wdt_resources, |
| }; |