blob: ee6b1cb27ce550fd76c8f1d3de25b0599050f34c [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0-only
/*
* Copyright (C) 2015 Phytec Messtechnik GmbH
* Author: Teresa Remmet <t.remmet@phytec.de>
*/
#include "am33xx.dtsi"
#include <dt-bindings/interrupt-controller/irq.h>
/ {
model = "Phytec AM335x phyCORE";
compatible = "phytec,am335x-phycore-som", "ti,am33xx";
aliases {
rtc0 = &i2c_rtc;
rtc1 = &rtc;
};
cpus {
cpu@0 {
cpu0-supply = <&vdd1_reg>;
};
};
memory@80000000 {
device_type = "memory";
reg = <0x80000000 0x10000000>; /* 256 MB */
};
regulators {
compatible = "simple-bus";
vcc5v: fixedregulator0 {
compatible = "regulator-fixed";
regulator-name = "vcc5v";
regulator-min-microvolt = <5000000>;
regulator-max-microvolt = <5000000>;
regulator-boot-on;
regulator-always-on;
};
};
};
/* Crypto Module */
&aes {
status = "okay";
};
&sham {
status = "okay";
};
/* Ethernet */
&am33xx_pinmux {
ethernet0_pins: pinmux_ethernet0 {
pinctrl-single,pins = <
AM33XX_PADCONF(AM335X_PIN_MII1_CRS, PIN_INPUT_PULLDOWN, MUX_MODE1)
AM33XX_PADCONF(AM335X_PIN_MII1_RX_ER, PIN_INPUT_PULLDOWN, MUX_MODE1)
AM33XX_PADCONF(AM335X_PIN_MII1_TX_EN, PIN_OUTPUT, MUX_MODE1)
AM33XX_PADCONF(AM335X_PIN_MII1_TXD1, PIN_OUTPUT, MUX_MODE1)
AM33XX_PADCONF(AM335X_PIN_MII1_TXD0, PIN_OUTPUT, MUX_MODE1)
AM33XX_PADCONF(AM335X_PIN_MII1_RXD1, PIN_INPUT_PULLDOWN, MUX_MODE1)
AM33XX_PADCONF(AM335X_PIN_MII1_RXD0, PIN_INPUT_PULLDOWN, MUX_MODE1)
AM33XX_PADCONF(AM335X_PIN_RMII1_REF_CLK, PIN_INPUT_PULLDOWN, MUX_MODE0)
>;
};
mdio_pins: pinmux_mdio {
pinctrl-single,pins = <
/* MDIO */
AM33XX_PADCONF(AM335X_PIN_MDIO, PIN_INPUT_PULLUP | SLEWCTRL_FAST, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_MDC, PIN_OUTPUT_PULLUP, MUX_MODE0)
>;
};
};
&cpsw_emac0 {
phy-handle = <&phy0>;
phy-mode = "rmii";
dual_emac_res_vlan = <1>;
};
&davinci_mdio {
pinctrl-names = "default";
pinctrl-0 = <&mdio_pins>;
status = "okay";
phy0: ethernet-phy@0 {
reg = <0>;
};
};
&mac {
slaves = <1>;
pinctrl-names = "default";
pinctrl-0 = <&ethernet0_pins>;
status = "okay";
};
/* I2C Busses */
&am33xx_pinmux {
i2c0_pins: pinmux_i2c0 {
pinctrl-single,pins = <
AM33XX_PADCONF(AM335X_PIN_I2C0_SDA, PIN_INPUT, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_I2C0_SCL, PIN_INPUT, MUX_MODE0)
>;
};
};
&i2c0 {
pinctrl-names = "default";
pinctrl-0 = <&i2c0_pins>;
clock-frequency = <400000>;
status = "okay";
tps: pmic@2d {
reg = <0x2d>;
};
i2c_tmp102: temp@4b {
compatible = "ti,tmp102";
reg = <0x4b>;
status = "disabled";
};
i2c_eeprom: eeprom@52 {
compatible = "atmel,24c32";
pagesize = <32>;
reg = <0x52>;
status = "disabled";
};
i2c_rtc: rtc@68 {
compatible = "microcrystal,rv4162";
reg = <0x68>;
status = "disabled";
};
};
/* NAND memory */
&am33xx_pinmux {
nandflash_pins: pinmux_nandflash {
pinctrl-single,pins = <
AM33XX_PADCONF(AM335X_PIN_GPMC_AD0, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_AD1, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_AD2, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_AD3, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_AD4, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_AD5, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_AD6, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_AD7, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_WAIT0, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_CSN0, PIN_OUTPUT, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_ADVN_ALE, PIN_OUTPUT, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_OEN_REN, PIN_OUTPUT, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_WEN, PIN_OUTPUT, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_GPMC_BEN0_CLE, PIN_OUTPUT, MUX_MODE0)
>;
};
};
&elm {
status = "okay";
};
&gpmc {
status = "okay";
pinctrl-names = "default";
pinctrl-0 = <&nandflash_pins>;
ranges = <0 0 0x08000000 0x1000000>; /* CS0: NAND */
nandflash: nand@0,0 {
compatible = "ti,omap2-nand";
reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
interrupt-parent = <&gpmc>;
interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
<1 IRQ_TYPE_NONE>; /* termcount */
rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */
nand-bus-width = <8>;
ti,nand-ecc-opt = "bch8";
gpmc,device-nand = "true";
gpmc,device-width = <1>;
gpmc,sync-clk-ps = <0>;
gpmc,cs-on-ns = <0>;
gpmc,cs-rd-off-ns = <30>;
gpmc,cs-wr-off-ns = <30>;
gpmc,adv-on-ns = <0>;
gpmc,adv-rd-off-ns = <30>;
gpmc,adv-wr-off-ns = <30>;
gpmc,we-on-ns = <0>;
gpmc,we-off-ns = <20>;
gpmc,oe-on-ns = <10>;
gpmc,oe-off-ns = <30>;
gpmc,access-ns = <30>;
gpmc,rd-cycle-ns = <30>;
gpmc,wr-cycle-ns = <30>;
gpmc,bus-turnaround-ns = <0>;
gpmc,cycle2cycle-delay-ns = <50>;
gpmc,cycle2cycle-diffcsen;
gpmc,clk-activation-ns = <0>;
gpmc,wr-access-ns = <30>;
gpmc,wr-data-mux-bus-ns = <0>;
ti,elm-id = <&elm>;
#address-cells = <1>;
#size-cells = <1>;
};
};
/* Power */
#include "tps65910.dtsi"
&tps {
vcc1-supply = <&vcc5v>;
vcc2-supply = <&vcc5v>;
vcc3-supply = <&vcc5v>;
vcc4-supply = <&vcc5v>;
vcc5-supply = <&vcc5v>;
vcc6-supply = <&vcc5v>;
vcc7-supply = <&vcc5v>;
vccio-supply = <&vcc5v>;
regulators {
vrtc_reg: regulator@0 {
regulator-always-on;
};
vio_reg: regulator@1 {
regulator-always-on;
};
vdd1_reg: regulator@2 {
/* VDD_MPU voltage limits 0.95V - 1.325V with +/-4% tolerance */
regulator-name = "vdd_mpu";
regulator-min-microvolt = <912500>;
regulator-max-microvolt = <1378000>;
regulator-boot-on;
regulator-always-on;
};
vdd2_reg: regulator@3 {
/* VDD_CORE voltage limits 0.95V - 1.1V with +/-4% tolerance */
regulator-name = "vdd_core";
regulator-min-microvolt = <912500>;
regulator-max-microvolt = <1150000>;
regulator-boot-on;
regulator-always-on;
};
vdd3_reg: regulator@4 {
regulator-always-on;
};
vdig1_reg: regulator@5 {
regulator-name = "vdig1_1p8v";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
};
vdig2_reg: regulator@6 {
regulator-always-on;
};
vpll_reg: regulator@7 {
regulator-always-on;
};
vdac_reg: regulator@8 {
regulator-always-on;
};
vaux1_reg: regulator@9 {
regulator-always-on;
};
vaux2_reg: regulator@10 {
regulator-always-on;
};
vaux33_reg: regulator@11 {
regulator-always-on;
};
vmmc_reg: regulator@12 {
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-always-on;
};
};
};
/* SPI Busses */
&am33xx_pinmux {
spi0_pins: pinmux_spi0 {
pinctrl-single,pins = <
AM33XX_PADCONF(AM335X_PIN_SPI0_SCLK, PIN_INPUT_PULLDOWN, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_SPI0_D0, PIN_INPUT_PULLDOWN, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_SPI0_D1, PIN_INPUT_PULLUP, MUX_MODE0)
AM33XX_PADCONF(AM335X_PIN_SPI0_CS0, PIN_INPUT_PULLUP, MUX_MODE0)
>;
};
};
&spi0 {
pinctrl-names = "default";
pinctrl-0 = <&spi0_pins>;
status = "okay";
serial_flash: m25p80@0 {
compatible = "jedec,spi-nor";
spi-max-frequency = <48000000>;
reg = <0x0>;
m25p,fast-read;
status = "disabled";
#address-cells = <1>;
#size-cells = <1>;
};
};