| # 64-bit ARM SoCs from TI | |
| if ARM64 | |
| if ARCH_K3 | |
| config ARCH_K3_AM6_SOC | |
| bool "K3 AM6 SoC" | |
| help | |
| Enable support for TI's AM6 SoC Family support | |
| endif | |
| endif | |
| # | |
| # TI SOC drivers | |
| # | |
| menuconfig SOC_TI | |
| bool "TI SOC drivers support" | |
| if SOC_TI | |
| config KEYSTONE_NAVIGATOR_QMSS | |
| tristate "Keystone Queue Manager Sub System" | |
| depends on ARCH_KEYSTONE | |
| help | |
| Say y here to support the Keystone multicore Navigator Queue | |
| Manager support. The Queue Manager is a hardware module that | |
| is responsible for accelerating management of the packet queues. | |
| Packets are queued/de-queued by writing/reading descriptor address | |
| to a particular memory mapped location in the Queue Manager module. | |
| If unsure, say N. | |
| config KEYSTONE_NAVIGATOR_DMA | |
| tristate "TI Keystone Navigator Packet DMA support" | |
| depends on ARCH_KEYSTONE | |
| help | |
| Say y tp enable support for the Keystone Navigator Packet DMA on | |
| on Keystone family of devices. It sets up the dma channels for the | |
| Queue Manager Sub System. | |
| If unsure, say N. | |
| config AMX3_PM | |
| tristate "AMx3 Power Management" | |
| depends on SOC_AM33XX || SOC_AM43XX | |
| depends on WKUP_M3_IPC && TI_EMIF_SRAM && SRAM | |
| help | |
| Enable power management on AM335x and AM437x. Required for suspend to mem | |
| and standby states on both AM335x and AM437x platforms and for deeper cpuidle | |
| c-states on AM335x. | |
| config WKUP_M3_IPC | |
| tristate "TI AMx3 Wkup-M3 IPC Driver" | |
| depends on WKUP_M3_RPROC | |
| depends on OMAP2PLUS_MBOX | |
| help | |
| TI AM33XX and AM43XX have a Cortex M3, the Wakeup M3, to handle | |
| low power transitions. This IPC driver provides the necessary API | |
| to communicate and use the Wakeup M3 for PM features like suspend | |
| resume and boots it using wkup_m3_rproc driver. | |
| config TI_SCI_PM_DOMAINS | |
| tristate "TI SCI PM Domains Driver" | |
| depends on TI_SCI_PROTOCOL | |
| depends on PM_GENERIC_DOMAINS | |
| help | |
| Generic power domain implementation for TI device implementing | |
| the TI SCI protocol. | |
| To compile this as a module, choose M here. The module will be | |
| called ti_sci_pm_domains. Note this is needed early in boot before | |
| rootfs may be available. | |
| endif # SOC_TI |