| # SPDX-License-Identifier: GPL-2.0 |
| config PPC_MPC52xx |
| bool "52xx-based boards" |
| depends on 6xx |
| select COMMON_CLK |
| select PPC_PCI_CHOICE |
| |
| config PPC_MPC5200_SIMPLE |
| bool "Generic support for simple MPC5200 based boards" |
| depends on PPC_MPC52xx |
| select DEFAULT_UIMAGE |
| help |
| This option enables support for a simple MPC52xx based boards which |
| do not need a custom platform specific setup. Such boards are |
| supported assuming the following: |
| |
| - GPIO pins are configured by the firmware, |
| - CDM configuration (clocking) is setup correctly by firmware, |
| - if the 'fsl,has-wdt' property is present in one of the |
| gpt nodes, then it is safe to use such gpt to reset the board, |
| - PCI is supported if enabled in the kernel configuration |
| and if there is a PCI bus node defined in the device tree. |
| |
| Boards that are compatible with this generic platform support |
| are: |
| intercontrol,digsy-mtc |
| phytec,pcm030 |
| phytec,pcm032 |
| promess,motionpro |
| schindler,cm5200 |
| tqc,tqm5200 |
| |
| config PPC_EFIKA |
| bool "bPlan Efika 5k2. MPC5200B based computer" |
| depends on PPC_MPC52xx |
| select PPC_RTAS |
| select PPC_NATIVE |
| |
| config PPC_LITE5200 |
| bool "Freescale Lite5200 Eval Board" |
| depends on PPC_MPC52xx |
| select DEFAULT_UIMAGE |
| |
| config PPC_MEDIA5200 |
| bool "Freescale Media5200 Eval Board" |
| depends on PPC_MPC52xx |
| select DEFAULT_UIMAGE |
| |
| config PPC_MPC5200_BUGFIX |
| bool "MPC5200 (L25R) bugfix support" |
| depends on PPC_MPC52xx |
| help |
| Enable workarounds for original MPC5200 errata. This is not required |
| for MPC5200B based boards. |
| |
| It is safe to say 'Y' here |
| |
| config PPC_MPC5200_LPBFIFO |
| tristate "MPC5200 LocalPlus bus FIFO driver" |
| depends on PPC_MPC52xx && PPC_BESTCOMM |
| select PPC_BESTCOMM_GEN_BD |
