| Analog Devices ADAU1701 |
| |
| Required properties: |
| |
| - compatible: Should contain "adi,adau1701" |
| - reg: The i2c address. Value depends on the state of ADDR0 |
| and ADDR1, as wired in hardware. |
| |
| Optional properties: |
| |
| - reset-gpio: A GPIO spec to define which pin is connected to the |
| chip's !RESET pin. If specified, the driver will |
| assert a hardware reset at probe time. |
| - adi,pll-mode-gpios: An array of two GPIO specs to describe the GPIOs |
| the ADAU's PLL config pins are connected to. |
| The state of the pins are set according to the |
| configured clock divider on ASoC side before the |
| firmware is loaded. |
| - adi,pin-config: An array of 12 numerical values selecting one of the |
| pin configurations as described in the datasheet, |
| table 53. Note that the value of this property has |
| to be prefixed with '/bits/ 8'. |
| - avdd-supply: Power supply for AVDD, providing 3.3V |
| - dvdd-supply: Power supply for DVDD, providing 3.3V |
| |
| Examples: |
| |
| i2c_bus { |
| adau1701@34 { |
| compatible = "adi,adau1701"; |
| reg = <0x34>; |
| reset-gpio = <&gpio 23 0>; |
| avdd-supply = <&vdd_3v3_reg>; |
| dvdd-supply = <&vdd_3v3_reg>; |
| adi,pll-mode-gpios = <&gpio 24 0 &gpio 25 0>; |
| adi,pin-config = /bits/ 8 <0x4 0x7 0x5 0x5 0x4 0x4 |
| 0x4 0x4 0x4 0x4 0x4 0x4>; |
| }; |
| }; |
