| Freescale Asynchronous Sample Rate Converter (ASRC) Controller |
| |
| The Asynchronous Sample Rate Converter (ASRC) converts the sampling rate of a |
| signal associated with an input clock into a signal associated with a different |
| output clock. The driver currently works as a Front End of DPCM with other Back |
| Ends Audio controller such as ESAI, SSI and SAI. It has three pairs to support |
| three substreams within totally 10 channels. |
| |
| Required properties: |
| |
| - compatible : Contains "fsl,imx35-asrc" or "fsl,imx53-asrc". |
| |
| - reg : Offset and length of the register set for the device. |
| |
| - interrupts : Contains the spdif interrupt. |
| |
| - dmas : Generic dma devicetree binding as described in |
| Documentation/devicetree/bindings/dma/dma.txt. |
| |
| - dma-names : Contains "rxa", "rxb", "rxc", "txa", "txb" and "txc". |
| |
| - clocks : Contains an entry for each entry in clock-names. |
| |
| - clock-names : Contains the following entries |
| "mem" Peripheral access clock to access registers. |
| "ipg" Peripheral clock to driver module. |
| "asrck_<0-f>" Clock sources for input and output clock. |
| "spba" The spba clock is required when ASRC is placed as a |
| bus slave of the Shared Peripheral Bus and when two |
| or more bus masters (CPU, DMA or DSP) try to access |
| it. This property is optional depending on the SoC |
| design. |
| |
| - fsl,asrc-rate : Defines a mutual sample rate used by DPCM Back Ends. |
| |
| - fsl,asrc-width : Defines a mutual sample width used by DPCM Back Ends. |
| |
| Optional properties: |
| |
| - big-endian : If this property is absent, the little endian mode |
| will be in use as default. Otherwise, the big endian |
| mode will be in use for all the device registers. |
| |
| Example: |
| |
| asrc: asrc@2034000 { |
| compatible = "fsl,imx53-asrc"; |
| reg = <0x02034000 0x4000>; |
| interrupts = <0 50 IRQ_TYPE_LEVEL_HIGH>; |
| clocks = <&clks 107>, <&clks 107>, <&clks 0>, |
| <&clks 0>, <&clks 0>, <&clks 0>, <&clks 0>, |
| <&clks 0>, <&clks 0>, <&clks 0>, <&clks 0>, |
| <&clks 0>, <&clks 0>, <&clks 0>, <&clks 0>, |
| <&clks 107>, <&clks 0>, <&clks 0>; |
| clock-names = "mem", "ipg", "asrck0", |
| "asrck_1", "asrck_2", "asrck_3", "asrck_4", |
| "asrck_5", "asrck_6", "asrck_7", "asrck_8", |
| "asrck_9", "asrck_a", "asrck_b", "asrck_c", |
| "asrck_d", "asrck_e", "asrck_f"; |
| dmas = <&sdma 17 23 1>, <&sdma 18 23 1>, <&sdma 19 23 1>, |
| <&sdma 20 23 1>, <&sdma 21 23 1>, <&sdma 22 23 1>; |
| dma-names = "rxa", "rxb", "rxc", |
| "txa", "txb", "txc"; |
| fsl,asrc-rate = <48000>; |
| fsl,asrc-width = <16>; |
| }; |