| // SPDX-License-Identifier: GPL-2.0+ |
| /** |
| * drivers/net/phy/rockchip.c |
| * |
| * Driver for ROCKCHIP Ethernet PHYs |
| * |
| * Copyright (c) 2017, Fuzhou Rockchip Electronics Co., Ltd |
| * |
| * David Wu <david.wu@rock-chips.com> |
| */ |
| |
| #include <linux/ethtool.h> |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/mii.h> |
| #include <linux/netdevice.h> |
| #include <linux/phy.h> |
| |
| #define INTERNAL_EPHY_ID 0x1234d400 |
| |
| #define MII_INTERNAL_CTRL_STATUS 17 |
| #define SMI_ADDR_TSTCNTL 20 |
| #define SMI_ADDR_TSTREAD1 21 |
| #define SMI_ADDR_TSTREAD2 22 |
| #define SMI_ADDR_TSTWRITE 23 |
| #define MII_SPECIAL_CONTROL_STATUS 31 |
| |
| #define MII_AUTO_MDIX_EN BIT(7) |
| #define MII_MDIX_EN BIT(6) |
| |
| #define MII_SPEED_10 BIT(2) |
| #define MII_SPEED_100 BIT(3) |
| |
| #define TSTCNTL_RD (BIT(15) | BIT(10)) |
| #define TSTCNTL_WR (BIT(14) | BIT(10)) |
| |
| #define TSTMODE_ENABLE 0x400 |
| #define TSTMODE_DISABLE 0x0 |
| |
| #define WR_ADDR_A7CFG 0x18 |
| |
| static int rockchip_init_tstmode(struct phy_device *phydev) |
| { |
| int ret; |
| |
| /* Enable access to Analog and DSP register banks */ |
| ret = phy_write(phydev, SMI_ADDR_TSTCNTL, TSTMODE_ENABLE); |
| if (ret) |
| return ret; |
| |
| ret = phy_write(phydev, SMI_ADDR_TSTCNTL, TSTMODE_DISABLE); |
| if (ret) |
| return ret; |
| |
| return phy_write(phydev, SMI_ADDR_TSTCNTL, TSTMODE_ENABLE); |
| } |
| |
| static int rockchip_close_tstmode(struct phy_device *phydev) |
| { |
| /* Back to basic register bank */ |
| return phy_write(phydev, SMI_ADDR_TSTCNTL, TSTMODE_DISABLE); |
| } |
| |
| static int rockchip_integrated_phy_analog_init(struct phy_device *phydev) |
| { |
| int ret; |
| |
| ret = rockchip_init_tstmode(phydev); |
| if (ret) |
| return ret; |
| |
| /* |
| * Adjust tx amplitude to make sginal better, |
| * the default value is 0x8. |
| */ |
| ret = phy_write(phydev, SMI_ADDR_TSTWRITE, 0xB); |
| if (ret) |
| return ret; |
| ret = phy_write(phydev, SMI_ADDR_TSTCNTL, TSTCNTL_WR | WR_ADDR_A7CFG); |
| if (ret) |
| return ret; |
| |
| return rockchip_close_tstmode(phydev); |
| } |
| |
| static int rockchip_integrated_phy_config_init(struct phy_device *phydev) |
| { |
| int val, ret; |
| |
| /* |
| * The auto MIDX has linked problem on some board, |
| * workround to disable auto MDIX. |
| */ |
| val = phy_read(phydev, MII_INTERNAL_CTRL_STATUS); |
| if (val < 0) |
| return val; |
| val &= ~MII_AUTO_MDIX_EN; |
| ret = phy_write(phydev, MII_INTERNAL_CTRL_STATUS, val); |
| if (ret) |
| return ret; |
| |
| return rockchip_integrated_phy_analog_init(phydev); |
| } |
| |
| static void rockchip_link_change_notify(struct phy_device *phydev) |
| { |
| /* |
| * If mode switch happens from 10BT to 100BT, all DSP/AFE |
| * registers are set to default values. So any AFE/DSP |
| * registers have to be re-initialized in this case. |
| */ |
| if (phydev->state == PHY_RUNNING && phydev->speed == SPEED_100) { |
| int ret = rockchip_integrated_phy_analog_init(phydev); |
| |
| if (ret) |
| phydev_err(phydev, "rockchip_integrated_phy_analog_init err: %d.\n", |
| ret); |
| } |
| } |
| |
| static int rockchip_set_polarity(struct phy_device *phydev, int polarity) |
| { |
| int reg, err, val; |
| |
| /* get the current settings */ |
| reg = phy_read(phydev, MII_INTERNAL_CTRL_STATUS); |
| if (reg < 0) |
| return reg; |
| |
| reg &= ~MII_AUTO_MDIX_EN; |
| val = reg; |
| switch (polarity) { |
| case ETH_TP_MDI: |
| val &= ~MII_MDIX_EN; |
| break; |
| case ETH_TP_MDI_X: |
| val |= MII_MDIX_EN; |
| break; |
| case ETH_TP_MDI_AUTO: |
| case ETH_TP_MDI_INVALID: |
| default: |
| return 0; |
| } |
| |
| if (val != reg) { |
| /* Set the new polarity value in the register */ |
| err = phy_write(phydev, MII_INTERNAL_CTRL_STATUS, val); |
| if (err) |
| return err; |
| } |
| |
| return 0; |
| } |
| |
| static int rockchip_config_aneg(struct phy_device *phydev) |
| { |
| int err; |
| |
| err = rockchip_set_polarity(phydev, phydev->mdix); |
| if (err < 0) |
| return err; |
| |
| return genphy_config_aneg(phydev); |
| } |
| |
| static int rockchip_phy_resume(struct phy_device *phydev) |
| { |
| genphy_resume(phydev); |
| |
| return rockchip_integrated_phy_config_init(phydev); |
| } |
| |
| static struct phy_driver rockchip_phy_driver[] = { |
| { |
| .phy_id = INTERNAL_EPHY_ID, |
| .phy_id_mask = 0xfffffff0, |
| .name = "Rockchip integrated EPHY", |
| /* PHY_BASIC_FEATURES */ |
| .flags = 0, |
| .link_change_notify = rockchip_link_change_notify, |
| .soft_reset = genphy_soft_reset, |
| .config_init = rockchip_integrated_phy_config_init, |
| .config_aneg = rockchip_config_aneg, |
| .suspend = genphy_suspend, |
| .resume = rockchip_phy_resume, |
| }, |
| }; |
| |
| module_phy_driver(rockchip_phy_driver); |
| |
| static struct mdio_device_id __maybe_unused rockchip_phy_tbl[] = { |
| { INTERNAL_EPHY_ID, 0xfffffff0 }, |
| { } |
| }; |
| |
| MODULE_DEVICE_TABLE(mdio, rockchip_phy_tbl); |
| |
| MODULE_AUTHOR("David Wu <david.wu@rock-chips.com>"); |
| MODULE_DESCRIPTION("Rockchip Ethernet PHY driver"); |
| MODULE_LICENSE("GPL"); |