| Required properties: |
| - compatible: Should be "qca,<soc>-eth". Currently support compatibles are: |
| qca,ar7100-eth - Atheros AR7100 |
| qca,ar7240-eth - Atheros AR7240 |
| qca,ar7241-eth - Atheros AR7241 |
| qca,ar7242-eth - Atheros AR7242 |
| qca,ar9130-eth - Atheros AR9130 |
| qca,ar9330-eth - Atheros AR9330 |
| qca,ar9340-eth - Atheros AR9340 |
| qca,qca9530-eth - Qualcomm Atheros QCA9530 |
| qca,qca9550-eth - Qualcomm Atheros QCA9550 |
| qca,qca9560-eth - Qualcomm Atheros QCA9560 |
| |
| - reg : Address and length of the register set for the device |
| - interrupts : Should contain eth interrupt |
| - phy-mode : See ethernet.txt file in the same directory |
| - clocks: the clock used by the core |
| - clock-names: the names of the clock listed in the clocks property. These are |
| "eth" and "mdio". |
| - resets: Should contain phandles to the reset signals |
| - reset-names: Should contain the names of reset signal listed in the resets |
| property. These are "mac" and "mdio" |
| |
| Optional properties: |
| - phy-handle : phandle to the PHY device connected to this device. |
| - fixed-link : Assume a fixed link. See fixed-link.txt in the same directory. |
| Use instead of phy-handle. |
| |
| Optional subnodes: |
| - mdio : specifies the mdio bus, used as a container for phy nodes |
| according to phy.txt in the same directory |
| |
| Example: |
| |
| ethernet@1a000000 { |
| compatible = "qca,ar9330-eth"; |
| reg = <0x1a000000 0x200>; |
| interrupts = <5>; |
| resets = <&rst 13>, <&rst 23>; |
| reset-names = "mac", "mdio"; |
| clocks = <&pll ATH79_CLK_AHB>, <&pll ATH79_CLK_MDIO>; |
| clock-names = "eth", "mdio"; |
| |
| phy-mode = "gmii"; |
| }; |