| /* SPDX-License-Identifier: GPL-2.0 */ |
| #ifndef _ASM_X86_PGTABLE_32_H |
| #define _ASM_X86_PGTABLE_32_H |
| |
| #include <asm/pgtable_32_types.h> |
| |
| /* |
| * The Linux memory management assumes a three-level page table setup. On |
| * the i386, we use that, but "fold" the mid level into the top-level page |
| * table, so that we physically have the same two-level page table as the |
| * i386 mmu expects. |
| * |
| * This file contains the functions and defines necessary to modify and use |
| * the i386 page table tree. |
| */ |
| #ifndef __ASSEMBLY__ |
| #include <asm/processor.h> |
| #include <linux/threads.h> |
| #include <asm/paravirt.h> |
| |
| #include <linux/bitops.h> |
| #include <linux/list.h> |
| #include <linux/spinlock.h> |
| |
| struct mm_struct; |
| struct vm_area_struct; |
| |
| extern pgd_t swapper_pg_dir[1024]; |
| extern pgd_t initial_page_table[1024]; |
| extern pmd_t initial_pg_pmd[]; |
| |
| static inline void pgtable_cache_init(void) { } |
| static inline void check_pgt_cache(void) { } |
| void paging_init(void); |
| void sync_initial_page_table(void); |
| |
| /* |
| * Define this if things work differently on an i386 and an i486: |
| * it will (on an i486) warn about kernel memory accesses that are |
| * done without a 'access_ok(VERIFY_WRITE,..)' |
| */ |
| #undef TEST_ACCESS_OK |
| |
| #ifdef CONFIG_X86_PAE |
| # include <asm/pgtable-3level.h> |
| #else |
| # include <asm/pgtable-2level.h> |
| #endif |
| |
| #if defined(CONFIG_HIGHPTE) |
| #define pte_offset_map(dir, address) \ |
| ((pte_t *)kmap_atomic(pmd_page(*(dir))) + \ |
| pte_index((address))) |
| #define pte_unmap(pte) kunmap_atomic((pte)) |
| #else |
| #define pte_offset_map(dir, address) \ |
| ((pte_t *)page_address(pmd_page(*(dir))) + pte_index((address))) |
| #define pte_unmap(pte) do { } while (0) |
| #endif |
| |
| /* Clear a kernel PTE and flush it from the TLB */ |
| #define kpte_clear_flush(ptep, vaddr) \ |
| do { \ |
| pte_clear(&init_mm, (vaddr), (ptep)); \ |
| __flush_tlb_one_kernel((vaddr)); \ |
| } while (0) |
| |
| #endif /* !__ASSEMBLY__ */ |
| |
| /* |
| * kern_addr_valid() is (1) for FLATMEM and (0) for |
| * SPARSEMEM and DISCONTIGMEM |
| */ |
| #ifdef CONFIG_FLATMEM |
| #define kern_addr_valid(addr) (1) |
| #else |
| #define kern_addr_valid(kaddr) (0) |
| #endif |
| |
| /* |
| * This is how much memory in addition to the memory covered up to |
| * and including _end we need mapped initially. |
| * We need: |
| * (KERNEL_IMAGE_SIZE/4096) / 1024 pages (worst case, non PAE) |
| * (KERNEL_IMAGE_SIZE/4096) / 512 + 4 pages (worst case for PAE) |
| * |
| * Modulo rounding, each megabyte assigned here requires a kilobyte of |
| * memory, which is currently unreclaimed. |
| * |
| * This should be a multiple of a page. |
| * |
| * KERNEL_IMAGE_SIZE should be greater than pa(_end) |
| * and small than max_low_pfn, otherwise will waste some page table entries |
| */ |
| #if PTRS_PER_PMD > 1 |
| #define PAGE_TABLE_SIZE(pages) (((pages) / PTRS_PER_PMD) + PTRS_PER_PGD) |
| #else |
| #define PAGE_TABLE_SIZE(pages) ((pages) / PTRS_PER_PGD) |
| #endif |
| |
| /* |
| * Number of possible pages in the lowmem region. |
| * |
| * We shift 2 by 31 instead of 1 by 32 to the left in order to avoid a |
| * gas warning about overflowing shift count when gas has been compiled |
| * with only a host target support using a 32-bit type for internal |
| * representation. |
| */ |
| #define LOWMEM_PAGES ((((2<<31) - __PAGE_OFFSET) >> PAGE_SHIFT)) |
| |
| #endif /* _ASM_X86_PGTABLE_32_H */ |