| # | |
| # USB Imaging devices configuration | |
| # | |
| comment "USB Imaging devices" | |
| depends on USB | |
| config USB_MDC800 | |
| tristate "USB Mustek MDC800 Digital Camera support" | |
| depends on USB | |
| ---help--- | |
| Say Y here if you want to connect this type of still camera to | |
| your computer's USB port. This driver can be used with gphoto 0.4.3 | |
| and higher (look at <http://www.gphoto.org/>). | |
| To use it create a device node with "mknod /dev/mustek c 180 32" and | |
| configure it in your software. | |
| To compile this driver as a module, choose M here: the | |
| module will be called mdc800. | |
| config USB_MICROTEK | |
| tristate "Microtek X6USB scanner support" | |
| depends on USB && SCSI | |
| help | |
| Say Y here if you want support for the Microtek X6USB and | |
| possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. | |
| Support for anything but the X6 is experimental. | |
| Please report failures and successes. | |
| The scanner will appear as a scsi generic device to the rest | |
| of the system. Scsi support is required. | |
| This driver can be compiled as a module, called microtek. |