# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/spi/qcom,spi-qcom-qspi.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Qualcomm Quad Serial Peripheral Interface (QSPI)

maintainers:
  - Bjorn Andersson <bjorn.andersson@linaro.org>

description: The QSPI controller allows SPI protocol communication in single,
  dual, or quad wire transmission modes for read/write access to slaves such
  as NOR flash.

allOf:
  - $ref: /schemas/spi/spi-controller.yaml#

properties:
  compatible:
    items:
      - enum:
          - qcom,sc7180-qspi
          - qcom,sc7280-qspi
          - qcom,sdm845-qspi

      - const: qcom,qspi-v1

  reg:
    maxItems: 1

  interrupts:
    maxItems: 1

  clock-names:
    items:
      - const: iface
      - const: core

  clocks:
    items:
      - description: AHB clock
      - description: QSPI core clock

  interconnects:
    minItems: 1
    maxItems: 2

  interconnect-names:
    minItems: 1
    items:
      - const: qspi-config
      - const: qspi-memory

  operating-points-v2: true

  power-domains:
    maxItems: 1

required:
  - compatible
  - reg
  - interrupts
  - clock-names
  - clocks

unevaluatedProperties: false

examples:
  - |
    #include <dt-bindings/clock/qcom,gcc-sdm845.h>
    #include <dt-bindings/interrupt-controller/arm-gic.h>

    soc: soc {
        #address-cells = <2>;
        #size-cells = <2>;

        qspi: spi@88df000 {
            compatible = "qcom,sdm845-qspi", "qcom,qspi-v1";
            reg = <0 0x88df000 0 0x600>;
            #address-cells = <1>;
            #size-cells = <0>;
            interrupts = <GIC_SPI 82 IRQ_TYPE_LEVEL_HIGH>;
            clock-names = "iface", "core";
            clocks = <&gcc GCC_QSPI_CNOC_PERIPH_AHB_CLK>,
                         <&gcc GCC_QSPI_CORE_CLK>;

            flash@0 {
                compatible = "jedec,spi-nor";
                reg = <0>;
                spi-max-frequency = <25000000>;
                spi-tx-bus-width = <2>;
                spi-rx-bus-width = <2>;
            };
        };
    };
...