ARM Mali Bifrost GPU
====================

Required properties:

- compatible :
  * Since Mali Bifrost GPU model/revision is fully discoverable by reading
    some determined registers, must contain the following:
    + "arm,mali-bifrost"
  * which must be preceded by one of the following vendor specifics:
    + "amlogic,meson-g12a-mali"

- reg : Physical base address of the device and length of the register area.

- interrupts : Contains the three IRQ lines required by Mali Bifrost devices,
  in the following defined order.

- interrupt-names : Contains the names of IRQ resources in this exact defined
  order: "job", "mmu", "gpu".

Optional properties:

- clocks : Phandle to clock for the Mali Bifrost device.

- mali-supply : Phandle to regulator for the Mali device. Refer to
  Documentation/devicetree/bindings/regulator/regulator.txt for details.

- operating-points-v2 : Refer to Documentation/devicetree/bindings/opp/opp.txt
  for details.

- resets : Phandle of the GPU reset line.

Vendor-specific bindings
------------------------

The Mali GPU is integrated very differently from one SoC to
another. In order to accommodate those differences, you have the option
to specify one more vendor-specific compatible, among:

- "amlogic,meson-g12a-mali"
  Required properties:
  - resets : Should contain phandles of :
    + GPU reset line
    + GPU APB glue reset line

Example for a Mali-G31:

gpu@ffa30000 {
	compatible = "amlogic,meson-g12a-mali", "arm,mali-bifrost";
	reg = <0xffe40000 0x10000>;
	interrupts = <GIC_SPI 160 IRQ_TYPE_LEVEL_HIGH>,
		     <GIC_SPI 161 IRQ_TYPE_LEVEL_HIGH>,
		     <GIC_SPI 162 IRQ_TYPE_LEVEL_HIGH>;
	interrupt-names = "job", "mmu", "gpu";
	clocks = <&clk CLKID_MALI>;
	mali-supply = <&vdd_gpu>;
	operating-points-v2 = <&gpu_opp_table>;
	resets = <&reset RESET_DVALIN_CAPB3>, <&reset RESET_DVALIN>;
};

gpu_opp_table: opp_table0 {
	compatible = "operating-points-v2";

	opp@533000000 {
		opp-hz = /bits/ 64 <533000000>;
		opp-microvolt = <1250000>;
	};
	opp@450000000 {
		opp-hz = /bits/ 64 <450000000>;
		opp-microvolt = <1150000>;
	};
	opp@400000000 {
		opp-hz = /bits/ 64 <400000000>;
		opp-microvolt = <1125000>;
	};
	opp@350000000 {
		opp-hz = /bits/ 64 <350000000>;
		opp-microvolt = <1075000>;
	};
	opp@266000000 {
		opp-hz = /bits/ 64 <266000000>;
		opp-microvolt = <1025000>;
	};
	opp@160000000 {
		opp-hz = /bits/ 64 <160000000>;
		opp-microvolt = <925000>;
	};
	opp@100000000 {
		opp-hz = /bits/ 64 <100000000>;
		opp-microvolt = <912500>;
	};
};