qeth: convert to hw_features part 2

Set rx csum default to hw checksumming again.
Remove sysfs interface for rx csum (checksumming) and TSO (large_send).
With the new hw_features it does not work to keep the old sysfs
interface in parallel. Convert options.checksum_type to new hw_features.

Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/s390/net/qeth_l2_main.c

diff --git a/drivers/s390/net/qeth_l2_main.c b/drivers/s390/net/qeth_l2_main.c
index 6fbaacb..8ba4c7e 100644
--- a/drivers/s390/net/qeth_l2_main.c
+++ b/drivers/s390/net/qeth_l2_main.c
@@ -420,10 +420,7 @@
 		case QETH_HEADER_TYPE_LAYER2:
 			skb->pkt_type = PACKET_HOST;
 			skb->protocol = eth_type_trans(skb, skb->dev);
-			if (card->options.checksum_type == NO_CHECKSUMMING)
-				skb->ip_summed = CHECKSUM_UNNECESSARY;
-			else
-				skb->ip_summed = CHECKSUM_NONE;
+			skb->ip_summed = CHECKSUM_NONE;
 			if (skb->protocol == htons(ETH_P_802_2))
 				*((__u32 *)skb->cb) = ++card->seqno.pkt_seqno;
 			len = skb->len;