[libata] use dev_printk() throughout drivers
A few drivers were not following the standard meme of printing out
their driver name and version at module load time; this is fixed
as well.
diff --git a/drivers/scsi/sata_sis.c b/drivers/scsi/sata_sis.c
index 057f7b9..42288be 100644
--- a/drivers/scsi/sata_sis.c
+++ b/drivers/scsi/sata_sis.c
@@ -38,6 +38,7 @@
#include <linux/blkdev.h>
#include <linux/delay.h>
#include <linux/interrupt.h>
+#include <linux/device.h>
#include "scsi.h"
#include <scsi/scsi_host.h>
#include <linux/libata.h>
@@ -237,6 +238,7 @@
static int sis_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
{
+ static int printed_version;
struct ata_probe_ent *probe_ent = NULL;
int rc;
u32 genctl;
@@ -245,6 +247,9 @@
u8 pmr;
u8 port2_start;
+ if (!printed_version++)
+ dev_printk(KERN_INFO, &pdev->dev, "version " DRV_VERSION "\n");
+
rc = pci_enable_device(pdev);
if (rc)
return rc;
@@ -288,16 +293,18 @@
pci_read_config_byte(pdev, SIS_PMR, &pmr);
if (ent->device != 0x182) {
if ((pmr & SIS_PMR_COMBINED) == 0) {
- printk(KERN_INFO "sata_sis: Detected SiS 180/181 chipset in SATA mode\n");
+ dev_printk(KERN_INFO, &pdev->dev,
+ "Detected SiS 180/181 chipset in SATA mode\n");
port2_start = 64;
}
else {
- printk(KERN_INFO "sata_sis: Detected SiS 180/181 chipset in combined mode\n");
+ dev_printk(KERN_INFO, &pdev->dev,
+ "Detected SiS 180/181 chipset in combined mode\n");
port2_start=0;
}
}
else {
- printk(KERN_INFO "sata_sis: Detected SiS 182 chipset\n");
+ dev_printk(KERN_INFO, &pdev->dev, "Detected SiS 182 chipset\n");
port2_start = 0x20;
}
