[media] drxk: Make the QAM demodulator command parameters configurable
Currently there are two different implementations (in the firmware) for
the QAM demodulator command: one takes 4 and the other takes 2
parameters. The driver shows an error in dmesg When using the
4-parameter command with firmware that implements the 2-parameter
command. Unfortunately this happens every time when chaning the
frequency (on DVB-C).
This patch simply makes configurable, how many command parameters will
be used. All existing drxk_config instances using the "drxk_a3.mc" were
updated because this firmware is the only loadable firmware where the
QAM demodulator command takes 4 parameters. Some firmwares in the ROM
might also use it. The drxk instances in the em28xx-dvb driver were also
updated to silence the warnings.
If no qam_demod_parameter_count is given in the drxk_config struct, then
the correct number of parameters will be auto-detected.
[mchehab@redhat.com: Fix a small CodingStyle issue at one comment]
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Tested-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/dvb/frontends/drxk_hard.h b/drivers/media/dvb/frontends/drxk_hard.h
index f417797..6bb9fc4 100644
--- a/drivers/media/dvb/frontends/drxk_hard.h
+++ b/drivers/media/dvb/frontends/drxk_hard.h
@@ -353,6 +353,7 @@
const char *microcode_name;
struct completion fw_wait_load;
const struct firmware *fw;
+ int qam_demod_parameter_count;
};
#define NEVER_LOCK 0
