* Amlogic Meson SAR (Successive Approximation Register) A/D converter

Required properties:
- compatible:	depending on the SoC this should be one of:
			- "amlogic,meson8-saradc" for Meson8
			- "amlogic,meson8b-saradc" for Meson8b
			- "amlogic,meson8m2-saradc" for Meson8m2
			- "amlogic,meson-gxbb-saradc" for GXBB
			- "amlogic,meson-gxl-saradc" for GXL
			- "amlogic,meson-gxm-saradc" for GXM
			- "amlogic,meson-axg-saradc" for AXG
		along with the generic "amlogic,meson-saradc"
- reg:		the physical base address and length of the registers
- interrupts:	the interrupt indicating end of sampling
- clocks:	phandle and clock identifier (see clock-names)
- clock-names:	mandatory clocks:
			- "clkin" for the reference clock (typically XTAL)
			- "core" for the SAR ADC core clock
		optional clocks:
			- "adc_clk" for the ADC (sampling) clock
			- "adc_sel" for the ADC (sampling) clock mux
- vref-supply:	the regulator supply for the ADC reference voltage
- #io-channel-cells: must be 1, see ../iio-bindings.txt

Optional properties:
- amlogic,hhi-sysctrl:	phandle to the syscon which contains the 5th bit
			of the TSC (temperature sensor coefficient) on
			Meson8b and Meson8m2 (which used to calibrate the
			temperature sensor)
- nvmem-cells:		phandle to the temperature_calib eFuse cells
- nvmem-cell-names:	if present (to enable the temperature sensor
			calibration) this must contain "temperature_calib"


Example:
	saradc: adc@8680 {
		compatible = "amlogic,meson-gxl-saradc", "amlogic,meson-saradc";
		#io-channel-cells = <1>;
		reg = <0x0 0x8680 0x0 0x34>;
		interrupts = <GIC_SPI 73 IRQ_TYPE_EDGE_RISING>;
		clocks = <&xtal>,
			 <&clkc CLKID_SAR_ADC>,
			 <&clkc CLKID_SANA>,
			 <&clkc CLKID_SAR_ADC_CLK>,
			 <&clkc CLKID_SAR_ADC_SEL>;
		clock-names = "clkin", "core", "sana", "adc_clk", "adc_sel";
	};