tree af8ce763bef242472331fbca5805b8066dbcde73
parent c1d84a1b42ef70d8ae601df9cadedc7ed4f1beb1
author Mikulas Patocka <mpatocka@redhat.com> 1534533577 -0400
committer David S. Miller <davem@davemloft.net> 1538977265 -0700

mach64: detect the dot clock divider correctly on sparc

On Sun Ultra 5, it happens that the dot clock is not set up properly for
some videomodes. For example, if we set the videomode "r1024x768x60" in
the firmware, Linux would incorrectly set a videomode with refresh rate
180Hz when booting (suprisingly, my LCD monitor can display it, although
display quality is very low).

The reason is this: Older mach64 cards set the divider in the register
VCLK_POST_DIV. The register has four 2-bit fields (the field that is
actually used is specified in the lowest two bits of the register
CLOCK_CNTL). The 2 bits select divider "1, 2, 4, 8". On newer mach64 cards,
there's another bit added - the top four bits of PLL_EXT_CNTL extend the
divider selection, so we have possible dividers "1, 2, 4, 8, 3, 5, 6, 12".
The Linux driver clears the top four bits of PLL_EXT_CNTL and never sets
them, so it can work regardless if the card supports them. However, the
sparc64 firmware may set these extended dividers during boot - and the
mach64 driver detects incorrect dot clock in this case.

This patch makes the driver read the additional divider bit from
PLL_EXT_CNTL and calculate the initial refresh rate properly.

Signed-off-by: Mikulas Patocka <mpatocka@redhat.com>
Cc: stable@vger.kernel.org
Acked-by: David S. Miller <davem@davemloft.net>
Reviewed-by: Ville Syrjälä <syrjala@sci.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>