sky2: enable rx/tx in sky2_phy_reinit()
sky2_phy_reinit is called by the ethtool helpers sky2_set_settings,
sky2_nway_reset and sky2_set_pauseparam when netif_running.
However, at the end of sky2_phy_init GM_GP_CTRL has GM_GPCR_RX_ENA and
GM_GPCR_TX_ENA cleared. So, doing these commands causes the device to
stop working:
$ ethtool -r eth0
$ ethtool -A eth0 autoneg off
Fix this issue by enabling Rx/Tx after running sky2_phy_init in
sky2_phy_reinit.
Signed-off-by: Brandon Philips <bphilips@suse.de>
Tested-by: Brandon Philips <bphilips@suse.de>
Cc: stable@kernel.org
Tested-by: Mike McCormack <mikem@ring3k.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 2111c7b..7985165 100644
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -717,11 +717,24 @@
sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF);
}
+/* Enable Rx/Tx */
+static void sky2_enable_rx_tx(struct sky2_port *sky2)
+{
+ struct sky2_hw *hw = sky2->hw;
+ unsigned port = sky2->port;
+ u16 reg;
+
+ reg = gma_read16(hw, port, GM_GP_CTRL);
+ reg |= GM_GPCR_RX_ENA | GM_GPCR_TX_ENA;
+ gma_write16(hw, port, GM_GP_CTRL, reg);
+}
+
/* Force a renegotiation */
static void sky2_phy_reinit(struct sky2_port *sky2)
{
spin_lock_bh(&sky2->phy_lock);
sky2_phy_init(sky2->hw, sky2->port);
+ sky2_enable_rx_tx(sky2);
spin_unlock_bh(&sky2->phy_lock);
}
@@ -2040,7 +2053,6 @@
{
struct sky2_hw *hw = sky2->hw;
unsigned port = sky2->port;
- u16 reg;
static const char *fc_name[] = {
[FC_NONE] = "none",
[FC_TX] = "tx",
@@ -2048,10 +2060,7 @@
[FC_BOTH] = "both",
};
- /* enable Rx/Tx */
- reg = gma_read16(hw, port, GM_GP_CTRL);
- reg |= GM_GPCR_RX_ENA | GM_GPCR_TX_ENA;
- gma_write16(hw, port, GM_GP_CTRL, reg);
+ sky2_enable_rx_tx(sky2);
gm_phy_write(hw, port, PHY_MARV_INT_MASK, PHY_M_DEF_MSK);
