gpio: syscon: add soc specific callback to assign output value
Some SoCs (like Keystone) may require to perform special
sequence of operations to assign output GPIO value, so default
implementation of .set() callback from gpio-syscon driver
can't be used.
Hence, add optional, SoC specific callback to assign output
gpio value.
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/gpio-syscon.c b/drivers/gpio/gpio-syscon.c
index 30884fb..d50ff93 100644
--- a/drivers/gpio/gpio-syscon.c
+++ b/drivers/gpio/gpio-syscon.c
@@ -37,6 +37,8 @@
* dat_bit_offset: Offset (in bits) to the first GPIO bit.
* dir_bit_offset: Optional offset (in bits) to the first bit to switch
* GPIO direction (Used with GPIO_SYSCON_FEAT_DIR flag).
+ * set: HW specific callback to assigns output value
+ * for signal "offset"
*/
struct syscon_gpio_data {
@@ -45,6 +47,8 @@
unsigned int bit_count;
unsigned int dat_bit_offset;
unsigned int dir_bit_offset;
+ void (*set)(struct gpio_chip *chip,
+ unsigned offset, int value);
};
struct syscon_gpio_priv {
@@ -111,7 +115,7 @@
BIT(offs % SYSCON_REG_BITS));
}
- syscon_gpio_set(chip, offset, val);
+ priv->data->set(chip, offset, val);
return 0;
}
@@ -159,7 +163,7 @@
if (priv->data->flags & GPIO_SYSCON_FEAT_IN)
priv->chip.direction_input = syscon_gpio_dir_in;
if (priv->data->flags & GPIO_SYSCON_FEAT_OUT) {
- priv->chip.set = syscon_gpio_set;
+ priv->chip.set = priv->data->set ? : syscon_gpio_set;
priv->chip.direction_output = syscon_gpio_dir_out;
}
