IPv6: Fix multicast routing bugs.
This patch addresses the IPv6 multicast routing issues described
below. It was tested with XORP 1.4/1.5 as the IPv6 PIM-SM routing
daemon against FreeBSD peers.
net/ipv6/ip6_input.c:
- Don't try to forward link-local multicast packets.
- Don't reset skb2->dev before calling ip6_mr_input() so packets can
be identified as coming from the PIM register vif properly.
net/ipv6/ip6mr.c:
- Fix incoming PIM register messages processing:
* The IPv6 pseudo-header should be included when checksumming PIM
messages (RFC 4601 section 4.9; RFC 3973 section 4.7.1).
* Packets decapsulated from PIM register messages should have
skb->protocol ETH_P_IPV6.
- Enable/disable IPv6 multicast forwarding on the corresponding
interface when a routing daemon adds/removes a multicast virtual
interface.
- Remove incorrect skb_pull() to fix userspace signaling.
- Enable/disable global IPv6 multicast forwarding when an IPv6
multicast routing socket is opened/closed.
net/ipv6/route.c:
- Don't use strict routing logic for packets decapsulated from PIM
register messages (similar to disabling rp_filter for the IPv4
case).
Signed-off-by: Thomas Goff <thomas.goff@boeing.com>
Reviewed-by: Fred Templin <fred.l.templin@boeing.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv6/route.c b/net/ipv6/route.c
index c4a5982..9c57423 100644
--- a/net/ipv6/route.c
+++ b/net/ipv6/route.c
@@ -794,7 +794,7 @@
.proto = iph->nexthdr,
};
- if (rt6_need_strict(&iph->daddr))
+ if (rt6_need_strict(&iph->daddr) && skb->dev->type != ARPHRD_PIMREG)
flags |= RT6_LOOKUP_F_IFACE;
skb->dst = fib6_rule_lookup(net, &fl, flags, ip6_pol_route_input);
