avr32: Fix MIMC200 board use of SPD network pins
The MIMC200 board uses the SPD output pin from the Ethernet MACs for
other purposes.
One of these is as a board-reset, so I've had to #define off the SPD
output pin declaration.
This is probably not the best way of achieving this, but works in the
current framework.
Signed-off-by: Mark Jackson <mpfj@mimc.co.uk>
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
diff --git a/arch/avr32/mach-at32ap/at32ap700x.c b/arch/avr32/mach-at32ap/at32ap700x.c
index 813b684..caec25a 100644
--- a/arch/avr32/mach-at32ap/at32ap700x.c
+++ b/arch/avr32/mach-at32ap/at32ap700x.c
@@ -1091,7 +1091,9 @@
pin_mask |= (1 << 11); /* RXD2 */
pin_mask |= (1 << 12); /* RXD3 */
pin_mask |= (1 << 14); /* RXCK */
+#ifndef CONFIG_BOARD_MIMC200
pin_mask |= (1 << 18); /* SPD */
+#endif
}
select_peripheral(PIOC, pin_mask, PERIPH_A, 0);
@@ -1112,8 +1114,10 @@
pin_mask |= (1 << 3); /* MDC */
pin_mask |= (1 << 2); /* MDIO */
+#ifndef CONFIG_BOARD_MIMC200
if (!data->is_rmii)
pin_mask |= (1 << 15); /* SPD */
+#endif
select_peripheral(PIOD, pin_mask, PERIPH_B, 0);
