tree 3386a102666376d1d987549d866f8232ec1aa8b1
parent 6ef19ab7fa1535d35006535dba6c407dad2d845c
author Gary Hade <garyhade@us.ibm.com> 1332368930 -0700
committer Len Brown <len.brown@intel.com> 1333092619 -0400

ACPI, APEI: Fix incorrect APEI register bit width check and usage

The current code incorrectly assumes that
(1) the APEI register bit width is always 8, 16, 32, or 64 and
(2) the APEI register bit width is always equal to the APEI
    register access width.

ERST serialization instructions entries such as:

[030h 0048   1]                       Action : 00 [Begin Write Operation]
[031h 0049   1]                  Instruction : 03 [Write Register Value]
[032h 0050   1]        Flags (decoded below) : 01
                      Preserve Register Bits : 1
[033h 0051   1]                     Reserved : 00

[034h 0052  12]              Register Region : [Generic Address Structure]
[034h 0052   1]                     Space ID : 00 [SystemMemory]
[035h 0053   1]                    Bit Width : 03
[036h 0054   1]                   Bit Offset : 00
[037h 0055   1]         Encoded Access Width : 03 [DWord Access:32]
[038h 0056   8]                      Address : 000000007F2D7038

[040h 0064   8]                        Value : 0000000000000001
[048h 0072   8]                         Mask : 0000000000000007

break this assumption by yielding:
  [Firmware Bug]: APEI: Invalid bit width in GAR [0x7f2d7038/3/0]

I have found no ACPI specification requirements corresponding
with the above assumptions.  There is even a good example in
the Serialization Instruction Entries section (ACPI 4.0 section
17.4,1.2, ACPI 4.0a section 2.5.1.2, ACPI 5.0 section 18.5.1.2)
that mentions a serialization instruction with a bit range of
[6:2] which is 5 bits wide, _not_ 8, 16, 32, or 64 bits wide.

Compile and boot tested with 3.3.0-rc7 on a IBM HX5.

Signed-off-by: Gary Hade <garyhade@us.ibm.com>
Signed-off-by: Len Brown <len.brown@intel.com>